Amplifier keying relay buffer interface TWO radios 2 linear switching with PS

Description

ONE or TWO radios keys ONE or TWO amplifiers with bypass switch
High quality relay box to interface between
any TWO radio
s and will key
any TWO amplifiers
Switch chooses
ONE
of
TWO
radios that will activate BOTH amplifiers or noise cancelling units
or choose center switch position to bypass the amplifiers
Many newer radios can only provide for a small amount of current on the external amplifier keying output.
Better SAFE than SORRY!
In response to your requests for a relay interface box that will key TWO completely separate amplifiers, we have developed the RBI-2a.
Do you have a need to key TWO amplifiers (perhaps a driver amp and high power amp) that have two different keying relay voltages? Our RBI-2 can (for example) key one amp with a 120 VAC T/R relay and your other amplifier that uses a 12 VDC T/R relay (or ANY voltage and current up to 240 volts ac/dc @ 5 amps for EACH amp). The keying circuits in our RBI-2a are COMPLETELY SEPARATE from each other and the radio is isolated. EACH output is a relay closure from center conductor of the RCA jack to the outside of the RCA jack. EACH output uses a completely SEPARATE relay!
WHY use two amplifiers?
Some users want to extend the life of their radio's expensive final transistors by running low power from their radio into an intermediate amplifier and have that amplifier run only what is needed to get full output from their higher power amplifier.
Some users want to use an "instant on" amplifier for most contacts but still also have a larger amplifier what may require warm up time that is less frequently used. With our box, you do not need to reach in back to disconnect and reconnect each amplifier keying line.
Some users have dedicated amplifiers for different bands and antennas and also don't want to to disconnect and reconnect individual relay keying cables
Our box will draw <1 MA from your radio and will key any TWO separate amplifiers. A very handy accessory. Get one BEFORE you damage your radios amplifier keying output!
RCA jacks in and out
Needs 9-15 VDC at only 65 ma. 12 vdc wall wart power supply included
Connect our RBI-2A to your radios keying circuit (ground center conductor to key our box)
Connect your amplifier relay keying input to either output on our RBI-2A, connect your other amp keying line to the other RBI-2a output
Relays rated up to 240 Volts at 5 AMPS, switch AC or DC any polarity!
Genuine relay used for switching (not an easy to damage solid state device)
Both amplifiers switch at the same time
Both amplifier keying lines are completely isolated from each other
Can switch an amplifier AN D noise cancelling device or anything that needs two wires connected together.
BYPASS switch (amplifiers are not keyed by either radio)
See separate ebay listing for RCA-RCA male connector cables
100% hand made and tested by Hams for Hams in Colorado
This is not one of those types that make you use a battery to power the unit! This high quality device is powered by your station power supply or any filtered DC source from 9-15 VDC (only 65 ma required) Need the best DC power supply? See our ebay store for SAMLEX power supplies.
Need to key only one amplifier? See our eBay store listing for the RBI-1 amplifier keying relay interface
Need to key up to SIX amplifiers? See our eBay store listing for the RBI-6a amplifier keying relay interface
Need to key MORE than two linears? Contact us for custom made amplifier PTT relay keying interfaces. (We just finished a SIX unit amp keying box, keyed from a single radio)
When connecting your Radio and Amplifier, there may be switching voltage, polarity, and current incompatibility  that can cause damage to your radio or amplifier if connected without a switching interface between them. Even if your internal radio switching looks like it might be usable, it is wise to have an extra degree of isolation between your amplifier and radio with our relay buffer interface.
73, Dan W7RF ( Radiodan )
Ham Radio linear amplifier amateur amatuer radio interface relay keying
Powered by
eBay Turbo Lister
The free listing tool. List your items fast and easy and manage your active items.