Remote BYPASS switch for Amplifier keying relay interface amateur radio linear

Description

This listing is for our Radiodan remote amplifier BYPASS switch box that will allow you to use
ONE radio to TWO amplifiers
or
TWO radios to ONE amplifier
There is no buffer inside this box, it's purpose is to allow bypassing your amplifier with an easy to mount switch box.
Put the BYPASS switch closer to where YOU want it.
1 - Center off (Bypass) - 2
When used as One radio to Two amps - The center cable goes to your radio keying circuit (we suggest using our RBI-1 interface), the other two go to each amplifier relay switching jack
When used as Two radios to One amp - the center cable goes to your amplifier (the other two go to your radio T/R keying, we suggest our RBI-1 interface)
Can also be used with just one radio and one amplifier.
Center conductors are switched, common ground shield of each cable are tied to together
Use mounting tabs on box with your screws or whatever mounting method you choose.
What is included? The box with center off switch and three RCA cables, just as shown.
We HIGHLY suggest the use of a high quality Amplifier Relay Buffer Interface like the Radiodan RBI-1
When connecting your Radio and Amplifier, there may be switching voltage, polarity, and current incompatibility  that can cause damage to your radio or amplifier if connected without a switching interface between them. Even if your internal radio switching looks like it might be usable, it is wise to have an extra degree of isolation between your amplifier and radio with our relay buffer interface.
See our eBay store listings for our complete line of Amplifier Relay Buffer Interfaces.
In other listings we have models with 2 radios and a bypass switch, 2 or more amplifiers or other device (like noise reduction unit keying, mute, etc)
Wire colors may vary
73, Dan W7RF ( Radiodan )
Ham Radio amplifier amateur amatuer radio amplifier relay interface Yeasu Kenwood ICOM Elecraft Ten Tec etc